Advertisement
How to set the woofer volume level
LOW : Set the woofer volume to low level.
This predefined volume setting is recommended when your
TV volume level is set to under 15.
MID : Set the woofer volume to middle level.
This predefined volume setting is recommended when your
TV volume level is set to between 15 and 40.
HIGH : Set the woofer volume to high level.
This predefined volume setting is recommended when your
TV volume level is set to over 40.
,
Note
y You can finely adjust the woofer volume level using
+/- buttons.
y Default volume level setting is LOW.
y If you feel unbalanced volume level between TV and
woofer, set the woofer volume level using HIGH/
MID/LOW buttons or using +/- buttons for fine
adjustment.
Refer to the supplied compatible TV list sheet and check whether your
TV is compatible or not.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon a
dedicated circuit;
That is, a single outlet circuit which powers only that
appliance and has no additional outlets or branch circuits.
Check the specification page of this owner' s manual to
be certain. Do not overload wall outlets. Overloaded wall
outlets, loose or damaged wall outlets, extension cords,
frayed power cords, or damaged or cracked wire insulation
are dangerous. Any of these conditions could result in
electric shock or fire. Periodically examine the cord of
your appliance, and if its appearance indicates damage or
deterioration, unplug it, discontinue use of the appliance,
and have the cord replaced with an exact replacement part
by an authorized service center. Protect the power cord
from physical or mechanical abuse, such as being twisted,
kinked, pinched, closed in a door, or walked upon. Pay
particular attention to plugs, wall outlets, and the point
where the cord exits the appliance. The Power Plug is the
disconnecting device. In case of an emergency, the Power
Plug must remain readily accessible
CAUTION : When cleaning the unit, do not use strong
solvents such as alcohol, benzine, or thinner, as these
might damage the surface of the unit.
Symbols
~
Refers to alternating current(AC).
Refers to direct current(DC).
0
Refers to class II equipment.
1
Refers to stand-by.
!
Refers to "ON" (power).
Refers to dangerous voltage.
Manufactured under license from
Dolby Laboratories. Dolby and the
double-D symbol are trademarks
of Dolby Laboratories.
Advertisement
