Hitachi BTN1 Owner's Manual page 15

Bluetooth
pairing fails
Audio is
interrupted or
breaks up
Speaker is not
responding
and will not
power off
• Check that the speaker is in the pairing
state (Bluetooth button is blinking). If it is
not, press and hold the Bluetooth button
(until it blinks) to set the speaker to
pairing mode and pair again.
• Make sure that the "Line In" (3.5mm)
cable is disconnected.
• Ensure that the speaker and Bluetooth
device to which it is connected are within
33 feet (10 meters) of each other.
• Ensure that there is no obstruction
between the speaker and the connected
Bluetooth device.
• Locate the small pinhole marked RESET
located on the right side of the speaker
(under the protective, rubber cover).
Insert a straightened paper clip through
the pinhole and depress the switch
inside. The speaker unit will automatically
power off.
15