Inserting The Microsd Card - Kenwood LZ-T700 Instruction Manual

Getting Started
Charging battery
This unit has a bulit-in battery which can
be charged from a vehicle power adapter
through USB cable. Charge completes in
about 3.5 hours.
LZ-T700
Notes
• Use the accessory USB cable. Using long
cable or extension cable may not charge the
battery. If you want to extend the cable, use the
Cigarette Socket Extension Cable.
• If the USB power source is less than 1A current,
the battery cannot be fully charged. (The
battery can only be charged to 80%, taking
approximately 8 hours).
Use a power source with at least 1A current.
Copying audio/video file from PC
Open the Windows Explorer and drag & drop
the desired file from the PC's hard disk drive
to LZ-T700. Copy & paste can also be used for
data transfer.
Connect LZ-T700 to your PC with USB
1
cable.
Find the device name LZ-T700 in the PC
2
and open the folder which you want to
put audio/video files.
Open the folder in the PC which audio/
3
video files are stored.
Drag & drop audio/video files from the
4
folder in the PC into the folder in LZ-T700.
4
English
B64-5135-00_00_K.indb 4
USB cable (2 m)
(provided accessory)
Vehicle power adapter
(provided accessory)
Notes
• Use the accessory USB cable. Files may not be
properly copied when using long cables or
extension cables.

Inserting the microSD card

Hold the microSD card with the label
1
side down and the notched section on
the left, and insert it into the slot until it
clicks.
Removing the microSD card
Push the microSD card until it clicks and
1
then remove your finger from the card.
The card pops up so that you can pull it
out with your fingers.
Note
• When purchased, the microSD port has a
dummy card inserted to protect microSD card
slot. Remove the dummy card before using
microSD.
13/02/22 15:5