Panasonic KX-TDA100 Installation Manual page 14

Telephone Company and F.C.C. Requirements and Responsibilities
For Cell Station
CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance
could void user's authority to operate this device.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a paticular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Some wireless telephones operate at frequencies that may cause interference to nearby TVs
and VCRs. To minimize or prevent such interference, the base of the wireless telephone should
not be placed near or on top of a TV or VCR. If interference is experienced, move the wireless
telephone further away from the TV or VCR. This will often reduce, or eliminate, interference.
Operating near 2.4 GHz electrical appliances may cause interference. Move away from the
electrical appliances and/or press the CH(Channel) button.
CAUTION
To comply with with FCC RF exposure requirements, the base unit should be installed with its
antenna located at 20 cm or more from persons.
• Medical – consult the manufacturer of any personal medical devices, such as pacemakers, to
determine if they are adequately shielded from external RF(radio frequency) energy. (The unit
operates in the frequency range of 2401 MHz to 2480 MHz, and the power output level can
range from 0.004 watts to 0.4 watts.) Do not use the unit in health care facilities if any
regulations posted in the area instruct you not to do so. Hospitals or health care facilities may
be using equipment that could be sensitive to external RF(radio frequency) energy.
14 Installation Manual