Table of Contents
Advertisement
1
Cannot be set when [Power on Setting] is [User 1] to [User 3].
2
This function will not work correctly in the following cases.
-
If the same function is assigned to multiple pins.
-
If the changes to the [Remote (GPI)] setting and the pin assignments were made when the pins were shorted.
3
The marker cannot be displayed when [Marker Preset] is set to [Off].
4
Can only be registered to [Pin7].
5
• If the message [Invalid operation due to high temperature.] is displayed, the fan cannot be stopped even when [On] is selected for this item.
Wait until the internal temperature lowers.
• If the temperature inside the main unit increases while the fan is off, the message [Fan will be rotated as the temperature is high.] is displayed
and the fan starts rotating approximately ten seconds later. Since the temperature of the main unit has increased, the fan rotates faster than
usual.
• Select [Off] to restart the fan. The fan rotates faster than usual.
• The fan may not stop in some conditions, for example when used at a high temperature.
6
• The following settings cannot be exported or imported.
Adjustment
Target values of Calibration (including calibration results)
Display Settings
Zoom Preset, Frame Hold
Function Settings Peaking (Enable), False Color (Enable), Test Pattern, Various Function (Monochrome, Blue Only, Red Off, Green Off,
Blue Off, 2020 Out of 709 Gamut View)
System Settings
Date/Time, Fan Stop, Export/Import, Power on Setting
• User LUT data cannot be exported or imported to [User 1] to [User 3] under [Target].
• Data exported from this product may not be imported to products of which firmware version is earlier than the version of this product. To import
data, update the firmware to the latest version.
OSD Menu
79
Advertisement
Table of Contents
