Advertisement
VIBRATE FUNCTION
With press the Menu key and Up key for (0.5) seconds to appear the Vibrate Icon on the
LCD with BEEP2. The Vibrate function will be operated as follows.
Receiving (After Carrier Detect for (1) second) at the FRS Mode
l_
Vibration for (1) second and stop for (0.5) seconds repeat three times
l¤
after then will be in the stand by until next receiving.
VIBRATE MODE RELEASING
l_
Transmission
l_
Monitor Operation
l_
Call Operation
With press the Menu Button and Down
l_
NOTICES TO USER
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
One or more of the following statements may be applicable:
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can generate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer for technical assistance.
SAFETY INFORMATION
Your wireless hand-held portable transceiver contains a low power transmitter. When the Push-to-
Talk (PTT) button is pushed it sends out radio frequency (RF) signals. The device is authorized to
operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications
Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held
wireless devices.
CAUTION: To maintain compliance with the FCC's RF exposure guidelines hold the transmitter and
antenna at least 2 inch (5 centimeters) from your face and speak in a normal voice, with the
antenna pointed up and away from the face. If you wear the handset on your body while using the
headset
accessory, use only the Kenwood supplied belt clip for this product and when transmitting, take it
out of the belt to ensure that the antenna is at least 1 inch (2.5 centimeters) from your body.
Use only the supplied antenna. Unauthorized antennas, modifications, or attachments could damage
the transmitter and may violate FCC regulations.
LIMITED WARRANTY STATEMENT
Kenwood Communications Corporation ("KENWOOD") warrants this product for
ninety (90) days on parts and labor, measured from the date of purchase by the first
end user. This Warranty is enforceable only by the first end user.
Except as specified below, this w arranty covers all defects in material and
workmanship in this product. The following are not covered by the Warranty:
1.
Damage, deterioration or failure resulting from:
A. Accident, misuse, abuse, neglect, product modification or failure to follow
Instructions contained in your Owner's Manual.
B. Repair or attempted repair by anyone not authorized by KENWOOD.
C. Installation of parts that do not conform to the quality or specifications of the
original parts.
2.
Damage or loss occurring during shipment (claims must be presented to the
Advertisement
