Hand -Held -Programmer -Setup - Toro TBC-HH User Manual

Hand Held Programmer Setup (Radio Users Only)
Since -a -single -
controllers, -the -
HHP -Number -(Programmer -I.D.) -(1–99) -and -a -separate -unique -
Controller -Number -(1–99). -Each -of -the -1–99 -Programmer -I.D. -can -
be -assigned -a -Controller -Number -1–99. -This -enables -the - -
-to -communicate -with -up -to -9,800 -individual -controllers. -
TBC HH
TM -
The -unique -
Programmer
set -in -each -controller -within -two -minutes -upon -initial -power -up. -
Mismatched -Programmer -I.D. -and -Controller -Number -during -
hand -held -to -controller -communication -will -return -an -ERROR -
message. -Follow -the -procedure -to -set -the -Programmer -I.D.
-Programmer -I.D. -and -Controller -Number -
NOTE
synchronization -is -only -required -for -wireless -radio -communication.
Step 1 - - - The -
value -can -be -changed -from -the -hand -held's -Advance -
Setup -function. -When -installing -the -battery -for -the -first -
time, -the -following -screen -will -immediately -display. -
-
- If -the -battery -is -already -installed -and -you -want -to -modify -
the -Programmer -I.D., -press -the -
is -displayed. -Press -the -
displayed.
Step 2 - - - Press -
Programmer -I.D. -you -would -like -to -assign -the -hand -held.
Step 3 - - - Press -the -
-
NOTE
establish -the -controller's -Programmer -I.D. -and -Controller -
Number.
Figure 3
Infrared (IR)
Communication
-may -be -used -to -connect -with -multiple -
TBC HH
TM -
-system -is -designed -to -have -a -unique -
TBC
TM -
-I.D. -and -Controller -Number -must -be -
-I.D. -is -set -during -initial -power -up -and -the -
TBC HH
TM -
-or -
ON OFF
-button -to -accept -the -change.
DIAL
-Proceed -to -Controller Setup -(pg. -7) -to -
Programmer I.D. Indicator
HHP - Hand-Held Programmer
DIAL
-button -until -above -screen -is -
NEXT
-button -to -select -the -appropriate -
Figure 4
Optional Wireless
Radio Communication
-button -until -ADVSET -