Table of Contents
Advertisement
HOW TO OPEN THE TRAY WHEN POWER SWITCH TURN OFF
Note 1: After the side panel (L, R) and top panel is removed, this work is done.
Note 2: Please prepare the thin wire (clip etc. processed to the length of 8 cm or more).
1 Remove the panel, side-L.
(Illustration of disassembly is omitted.)
–
Side view
–
hole
Insert the clip etc.
processed to the
length of 8 cm or
more in the hole
on the side of the
chassis and push.
8 cm or more
Note: Push after it inserts it in this hole well.
PRECAUTION WHEN INSTALLING A NEW OP UNIT/PRECAUTION BEFORE UNSOLDERING THE STATIC
ELECTRICITY PREVENTION SOLDER BRIDGE
When installing a new OP unit, be sure to connect the fl exible printed circuit board fi rst of all before removing the static electricity preven-
tion solder bridge by unsoldering.
Remove the static electricity prevention solder bridge by unsoldering after the fl exible printed circuit board has already been connected.
(Do not remove nor unsolder the solder bridge as long as the OP unit is kept standalone.)
CD drive
2 Insert the clip etc.
tray
–
Top view
–
HCD-GPX33/GPX55/GPX77/GPX88
tray
3
5
Hide quick links:
Advertisement
Table of Contents
