Wiring Method; Preparation Of Electric Wires; Processing Of Electric Wires - Panasonic Melody Week Instruction & Installation Manual

Wiring method

Interrupt iripl{t
Mei' � ttv' s ibn�1 cnitpu. · .
,
,
' ,,-/ ,
-�MtW
1. If used improper wire, it may cause a burn or a fire.
2. Never use a soldered wire. A thinner solder will cause imperfect contact and a fire.

Processing of electric wires

1. Electric wires for screw terminals
•when single wires are used Peel off
wire covering up to 11 ±1 mm.
(Full scale view) �
2. Electric wire for melody signal output
W) '---- �
Shielded wire
® q�����������-��I P
G)
Put through the cap.
* Connect a plug for an amplifier input using the same procedure as used for the melody signal output plug.
600V vinyl insulated wire
• Single wire: Dia.1.2 to 1.6 mm
• Twisted wire: 1.25 to 2 mm
Same as above
Dia. 0.65 mm, two-core twisted pair
Dia. 0.65 mm, two-core twisted pair
2 mm , two-core twisted pair wire
2
1.25 mm , two-core twisted pair wire
2
t
0.3 mm or more, single-core shielded wire
2
0.3 mm or more, single-core shielded wire
2
� �
�
,
.. Cap
®
Solder the wire and the metal fitting together.
Turn the cap.
-33-
No special provisions
Supply voltage:
2
Depends on loads
•when twisted wires are used Use
round crimp-type terminals with
insulation tubes (for M3.5).
Dia. 3.9 mm or more
Melody output side
@
Tighten the metal fitting on the shielded side.
110 V AC, 220 V AC or
240 V AC± 10 %
100 m
30 m
50 m
30 m
10 m
Sm
7 mm or less