Jumpers Setup - Panasonic NN30320A User Manual

Regulations 320R202E
No.

2.2 Jumpers Setup

MODE pin, FSEL pin, EN pin, PGOOD pin are able to be controlled by J-MODE, J-FSEL, J-EN, J-PGOOD.
Figure 3. Appearance of J-EN, J-MODE, J-FSEL
Figure 4. Appearance of J-PGOOD
Note: The parameters above is subject to change for improvement without notice.
2013-05-07
Revised
User's Guide
for Evaluation Board
Table 3. J-FSEL（Control SW frequency）
Jumper
Frequency
Table 5. J-PGOOD (Control the Voltage PGOOD pin pulled up to）
Jumper
Pull up to
Automotive & Industrial Systems Company, Panasonic Corporation
Total Pages
Table 2. J-MODE (Control modes）
J-MODE
Jumper
Mode FCCM
J-FSEL
J-FSEL
210kHz 650kHz
Table 4. J-EN (Control enable/disable）
J-EN
Jumper
Status enable
J-PGOOD
VREG
NN30320A-EVB
Page
14 6
J-MODE
SKIP
J-FSEL
430kHz
J-EN
disable
J-PGOOD
V-EXT