D-Link DIR-130 Troubleshooting Manual

Can not access the router on 192.168.0.1

Hide thumbs Also See for DIR-130:

Download this manual See also: User Manual

Troubleshooting - Can not access the router on 192.168.0.1

Please note that when accessing the router's Web interface via

http://192.168.0.1

you are not accessing the webpages on the

Internet, they are built into the router. You do not have to be online to get to these pages, you just need to be connected to the

router. Please also make sure you disable all anti-virus/firewall software on your computer.

Step 1. Connect your computer's network port to one of your router's LAN ports (Ethernet ports) using a network cable. WAN

port of the router should be connected to your modem.

Verify physical connectivity by checking for solid link lights on the Ethernet ports of the device. If you do not get a solid link light,

try using a different cable or connect to a different port on the device if possible. If the computer is turned off, the link light may

not be on.

Step 2. Under

Control Panel

Network Connections

Local Area Connection

... make sure that your

is enabled and not

bridged with any other connection. If you see any icon which is called "Bridge" - delete it.

If you see your

Local Area Connection

marked as "Bridged" - right-click

Local Area Connection

and select "

Remove from

Bridge

D-Link Technical

Support – Cannot access the routers web interface.

Page 1 of 4

Page 1 If you see any icon which is called "Bridge" - delete it. If you see your Local Area Connection marked as "Bridged" - right-click Local Area Connection and select " Remove from Bridge ". D-Link Technical Support – Cannot access the routers web interface. Page 1 of 4...
Page 2 Most DI-series devices use the 192.168.0.x range. If you are attempting to configure a D-Link router, then make sure you take note of your computer's Default Gateway IP address. The Default Gateway should be the IP address of the D-Link router.
Page 3 Click OK . Click OK out to the desktop and close any open windows. Restart Internet Explorer and try to access the router. D-Link Technical Support – Cannot access the routers web interface. Page 3 of 4...
Page 4 "The specified entry was not found" message. Try to access the router again. Reset the router. Try using another computer. D-Link Technical Support – Cannot access the routers web interface. Page 4 of 4...