Procedure After Replacing The Carriage Unit Or Multi Sensor - Canon iPF6100 Service Manual

Chapter 4
8) Retighten the two screws [1] loosened in Step 2) to secure the wire guide.
9) Pass the ink tubes through the wire guides.

4.5.4 Procedure after Replacing the Carriage Unit or Multi Sensor

iPF6300 / iPF6350 / iPF6300S
a) Multi Sensor Recalibration
Since the multi sensor has individual electrical specificity, the following are recalibrated at the factory, namely, the optical axis of the sensor, the sensor gain for
measuring the printhead height and sensor calibration. Accordingly, carry out the following adjustments in the service mode whenever replacing the carriage unit
or multi sensor.
- Service mode : SERVICE MODE > ADJUST > GAP CALIB.
- Service mode : SERVICE MODE > ADJUST > PRINT PATTERN > OPTICAL AXIS
Media type : Photo glossy paper
Media size : Media having a width equal too larger than that of A2-size paper
The multi sensor reference plate(QL2-2423-000:PLATE, REFLECTION, MULTI-SENSOR) must be replaced at the same time whenever the carriage or the multi
sensor is being replaced.
b) Carriage Motor Adjustment
- After the carriage and carriage motor and carriage belt and linear encoder sensor has been removed or replaced, execute the following service mode.
Service mode: SERVICE MODE > ADJUST > CR MOTOR COG
4-90
[1]
F-4-187
0024-9208