Zanussi ZDC8203W User Manual page 3

The ventilation opening in the base must not be covered by a
•
carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied through an
•
external switching device, such as timer, or connected to a
circuit that is regularly switched on and off by a utility.
Connect the mains plug to the mains socket only at the end of
•
the installation process. Make sure that the mains plug is
accessible after installation.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Do not exceed the maximum load of 8 kg (refer to the
•
"Programme chart" chapter).
Do not use the appliance if items have been soiled with
•
industrial chemicals.
Wipe away lint or packaging debris that has accumulated
•
around the appliance.
Do not run the appliance without a filter. Clean the lint filter
•
before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such as cooking
•
oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot
water with an extra amount of detergent before being dried in
the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in the
tumble dryer.
Fabric softeners, or similar products, should only be used as
•
specified by the product manufacturer's instructions.
Remove all objects from items that could be a source of fire
•
ignition such as lighters or matches.
WARNING: Never stop a tumble dryer before the end of the
•
drying cycle unless all items are quickly removed and spread
out so that the heat is dissipated.
3