Connections - GE S768DAV User Manual

Installation
Look inside the enclosure to determine the location of the socket for the edge connector on the
1)
card. Orient the card so that it will seat in the socket, and slide it into the card guides in the
enclosure until the edge connector at the back of the card seats in the socket. Seating may require
thumb pressure on the top and bottom of the card's front panel.
CAUTION:
Do not to press on any of the LEDs when installing cards into the enclosure. Equipment damage may
result.
Tighten the two thumbscrews on the card until the front panel of the card is seated against the front
2)
of the enclosure.
Determine where the module will be installed, and ensure that there is adequate space for making
3)
the various cable connections and for reading the diagnostic LEDs.
NOTE: The type of screws chosen must be suitable for the surface on which the module is to be mounted.
Standalone modules can be attached to suitable flat surfaces with four No. 6 (3 mm) screws. After
4)
the enclosure is securely attached to a flat surface, the cable connections can be made.
Figure 8. 502R Rack Card Enclosure Mounting Data
C
3.3
ONNECTIONS
All video, audio, data, contact, and fiber connections are made to the back panel of the S768DAV
module. When connecting audio, data, or contact signals, always wire the signal OUT pins on the
audio/data equipment to the signal IN pins on the fiber links, and the signal IN pins on the audio/data
equipment to the signal OUT pins on the fiber links. See Figure 9.
14
S768DAV – S7768DAV User Manual
11-0768DAV-B/ December 2003