Table of Contents
Advertisement
10
en | Connection
Figure 4.1: FPA-1000-V2 Network connections example
Note: If any one connection (for example, connection 5 shown as a dotted line) between one
panel and the next is not connected, the circuit is a Class B circuit. If all connections
between panels are made, the circuit is Class X.
4.2.2
Connecting card to card
Notice!
Although there is an Ethernet port on the panel's Mainboard, this port is reserved for
programming and reporting and should not be used for peer-to-peer communications.
Peer-to-peer communication connections should be made from one networking card to
another.
To connect one network card to another, use the following procedure:
Caution!
Be sure to configure ground fault detection so that it is only present at one end of each
!
connection.
1.
2017.11 | 2.0 | F.01U.214.374
1 Wired connection from one
FPE‑1000‑NW card to another
3 Ethernet connection from an
FPE‑1000‑NE card to an FPE‑1000‑NF
card
5 Ethernet connection from an FPE‑1000‑NF card to an FPA‑1000‑NW card
Plug one end of the chosen interconnection cable into an appropriate port on the
networking card installed in one of the two panels to be interconnected. Make a note of
the port that is used for this connection.
2 Ethernet connection from an
4 Fiber optic connection from one
Installation manual
FPA-1000-V2 Network Cards
FPE‑1000‑NW card to an FPE‑1000‑NE
card
FPE‑1000‑NF card to another
Bosch Security Systems, Inc.
Advertisement
Table of Contents
