Advertisement
Audio Indicators for Programmable
Buttons
Some programmable buttons use audio
indicators to indicate the change as they
alternate between two different choices.
Programmable
Positive
Button
Indicator Tone
Zone
In Zone 2
Repeater/
In Talkaround
Talkaround
mode
Start Scan
Scan
operation
Operating in
Squelch
tight squelch
Transmitting at
Power Level
low power
The horns
Horns and
and lights
Lights
feature is on
Tones and
All tones and
Alerts
alerts are on
Powering Up and Turning Off the
Radio
Press the On/Off Button briefly to turn on the
radio, and press and hold the On/Off Button to
turn it off.
Adjusting the Volume
Turn the Volume Knob clockwise to increase
volume or counterclockwise to decrease volume.
English
NOTE: Your radio can be programmed to have a
minimum volume offset where the
volume level cannot be turned down
fully. Check with your dealer or system
administrator for more information.
Negative
Accessing the Radio from Password
Indicator Tone
Power up the radio.
In Zone 1
1
You hear a continuous tone.
In Repeater
mode
2
Press the Channel Rocker to select a digit
Stop Scan
and Front Button P2 to enter the selected
operation
digit. Enter the remaining digits of the
password in the same manner.
Operating in
normal squelch
3
When the last digit of the four-digit password
Transmitting at
is entered, your radio automatically checks
high power
the validity of the password.
The horns
If the password is correct:
and lights
Your radio proceeds to power up.
feature is off
OR
All tones and
If the password is incorrect:
alerts are off
You hear a continuous tone. Repeat Steps 1
and 2.
OR
After the third incorrect password, your radio
enters into locked state. A tone sounds and
the yellow LED double blinks.
Your radio enters into locked state for 15
minutes, and responds to inputs from On/Off
button.
NOTE: The radio is unable to receive any call,
including emergency calls, in locked
state.
The use of Emergency footswitch
cancels out password input to access the
radio.
Selecting a Zone
1
Press the programmed Zone button.
2
You hear a positive indicator tone, indicating
the radio has switched from Zone 1 to Zone 2.
OR
You hear a negative indicator tone, indicating
the radio has switched from Zone 2 to Zone 1.
Selecting a Radio Channel,
Subscriber ID, or Group ID
1
Select the zone by pressing the programmed
Zone button to switch between zones.
2
Press the Channel Rocker to select the
required channel, subscriber ID, or group ID.
Capacity Plus
Press the Channel Rocker to access channels
with Capacity Plus.
Advertisement
