Advertisement
1. In-band tuner tuned A/V channel Navigation
1)
Without a cable card, turn the power on.
After the system boots, it will tune to a
preset channel like the screen on the left.
(Note) The first channel is tuned using saved
Channel information from the clear QAM
signal that is currently broadcasted from
the research lab.
(note) The banner OSD is setup to display the
currently tuned channel number.
2) If the remote control or front panel's CH UP
or CH DN key is pressed, the A/V will mute and
tune to the next channel.
At this time the currently tuned channel number
will be displayed on the banner OSD. The
channel banner will automatically disappear
after 3 seconds.
3) If the channel change is complete, the
banner OSD will disappear and A/V will output.
Advertisement
