Assembly; Fitting The Main Body; Assembling The Handlebar And Throttle - Husqvarna 541RS Operator's Manual

H1159210-30, GBESPT Page 12 Friday, October 6, 2017 1:00 PM

Fitting the main body

Connect the engine (A) to the tube (B) with four screws
(C).
A
B
C
Assembling the handlebar and
throttle
531RS 541RS
• Fit the handlebar in the handlebar clamp on the shaft
using four screws.
12 – English

ASSEMBLY

• Fit the protective sleeve as shown in the diagram.
541RST
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Fit the mounting components as shown.
• Loosely tighten the four screws.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.