Pioneer AVH-P3100DVD Service Manual page 99

5
CRG Mecha_Bringing into the Clamp State with No Disc Loaded
1.Remove the T-case washer and then remove the drive gear. (Fig. 1)
2.Lift the clamp arm assy until it is in the state shown in Fig. 2_b (open-lock state).
3.Put your finger on the area A of Fig. 2_c and then slide it to the direction of the arrow (the direction of the playing state).
4.Push down the clamp arm.
(Precaution) When bringing the CRG mecha into the ejecting state again, install the drive gear after sliding the drive lever
and bringing it to the ejecting state, in order to prevent the cog of the pinion in the drive gear from chipping at the time of
its installation.
Fig. 1
Fig. 2
a.Ejecting state b.Open-lock state
There is a
space
5
6
T-case washer
Drive gear
c.Clamp state with no disc loaded
There is
no space
AVH-P3100DVD/XN/UC
6
7
A
7
8
A
B
C
D
E
F
99
8