Part Names; Part Names And Functions Of The Remote Controller - Toshiba MMW-AP0271LQ-E Owner's Manual

2

Part names

 Hot water module
Electrical control box
Earth screw
Equipped on the electrical
control box
3
Part names and functions of the remote
controller
 Display section
All indicators are displayed in the display example below.
Actually, only the selected options will be displayed.
• blinks on the display of the remote controller the first time the power
switch is turned on.
• The initial settings progress while
controller after has disappeared.
NOTE
The LCD may temporarily be blurred due to static electricity.
11-EN
Water outlet
Water inlet
Drain pan
TEMP.
is blinking. Start to use the remote
TIMER SET FAN
TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX
4
1
SETTING indicator
Displayed when setting the timer or other
functions.
2
Operation mode indicator
Indicates the operation mode selected.
3
Error indicator
Displayed when the protective device activates or
an error occurs.
4
Time display
Indicates time concerning the timer.
(Indicates an error code when an error occurs)
5
Timer mode indicator
Displays the timer mode.
6
TEST run indicator
Displayed during test run.
7
Set temperature display
The selected set temperature is displayed.
8
Display Pre-heat indicator
section
Displayed when defrost cycle is initiated.
9
ON / OFF
No function indicator
Operation
MODE
section Displayed when the function requested is not
VENT
available on that model.
UNIT LOUVER
– 6 –
10
1 6
2
3
5
13
10
Central control indicator
Displayed when the air conditioner is controlled
centrally and used with central control devices
such as the central remote controller.
If the use of the remote controller is prohibited by
the central control,
MODE, or TEMP. button on the remote controller
is pushed, and the buttons do not function.
(Settings that can be configured on the remote
controller differ depending on the mode of the
central control. For details, read the Owner's
Manual of the central remote controller.)
11
Operation mode controlled indicator
Displayed when the operation mode is restricted.
12
Operation ready display
This display appears on some models.
13
Service display
Displayed while the protective device works or an
error occurs.
CAUTION
Remote controller sensor can not
be used for the hot water module.
Remote controller sensor has no
function when remote controller
is connected to the hot water
module.
7
11
12
8
9
blinks when the ON/OFF,
12-EN