Loading Files; Copying Files - Sony MVS-8000X User Manual

For frame memory file operations, frame memory folder
specification and data type selection is required.
Perform the following operation using the procedure in
"Saving Files" (page 379).
• In steps 2 and 3, specify the frame memory folder.
In the device selection area, press [DEFAULT] (default
setting), then select the target folder in the pull-down
menu.
• After step 3, select the data type to display using the
buttons above the list.
Still: Still image files
Clip: Clip files
Ext Clip: Extended clip files
All: All file types

Loading Files

This section describes loading a snapshot file from the
local drive or removable drive into a register as an
example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Register].
3
In the device selection area in the list on the right,
select [Local Drive] or [Removable Drive], then
specify a directory.
4
Select the register to which you want to load, and the
file to be loaded.
You can select more than one file.
To select all files, press [ALL].
5
Press [T Load].
The selected file is loaded.
Loading frame memory files
Notes
• When the signal format is 1080P, extended clip files
cannot be loaded.
• In a still image file saved in the 1080P signal format,
there are two still image files for each frame image. If
either of these two files is missing, it is not possible to
recreate the image, and therefore for correct operation
the two files must always be recalled together.
For frame memory file operations, frame memory folder
specification and data type selection is required.
Perform the following operation using the procedure in
"Loading Files" (page 380).
• In steps 2 and 3, specify the frame memory folder.
In the device selection area, press [DEFAULT] (default
setting), then select the target folder in the pull-down
menu.
• After step 3, select the data type to display using the
buttons above the list.
Still: Still image files
Clip: Clip files
Ext Clip: Extended clip files
All: All file types

Copying Files

You can copy files either within a directory or between
directories on the local drive or a removable drive.
This section describes copying a snapshot file from a
removable drive to the local drive as an example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Removable Drive], then specify a directory.
3
In the device selection area in the list on the right,
select [Local Drive], then specify a directory.
4
Select the source and destination files.
You can select more than one file.
To select all files, press [ALL].
5
Press [t Copy].
The selected files are copied.
If there is already data present in the destination
location, a confirmation message appears. Select [Yes]
to overwrite the data.
Copying frame memory files
Note
In a still image file saved in the 1080P signal format, there
are two still image files for each frame image. If either of
these two files is missing, it is not possible to recreate the
image, and therefore for correct operation the two files
must always be copied together.
For frame memory file operations, frame memory folder
specification and data type selection is required.
Perform the following operation using the procedure in
"Copying Files" (page 380).
• In steps 2 and 3, specify the frame memory folder.
In the device selection area, press [DEFAULT] (default
setting), then select the target folder in the pull-down
menu.
381