Table of Contents
Advertisement
2. Installing Web PDI
Setting the netmask address
After setting the gateway address, the netmask address should be set. Set the netmask address as follows:
1.
Press the 'MENU/SELECT' button of the Web PDI and then press Left/Right ( , ) button to
display the following Netmask setup screen. Press the 'MENU/SELECT' button again. The screen
to enter the netmask address is displayed.
MENU/
SELECT
2.
Use Up/Down/Left/Right (
MENU/
SELECT
3.
After entering the netmask address, press the 'MENU/SELECT' button to set the entered netmask
address. But, there is no 'MENU/SELECT' button pressed for a specific period (about 5 seconds), it
returns to the initial screen with the entered netmask address not applied to the system, and the
existing set netmask address is used.
MENU/
SELECT
2-14
Web PDI
Click
MENU
/SELECT
button
) button to enter the desired net mask address.
Example to set Netmask address
[MENU]
Set Netmask
[Set Netmask]
255.255.255.000
[Set Netmask]
255.255.255.000
Web PDI
SW ver. 1.0.0
Advertisement
Table of Contents
