INSTALLING THE ANTENNA (OPTIONAL)
Screw the antenna into the connector
on the top of the transceiver by holding
the antenna at its base and turning it
clockwise until secure.
INSTALLING THE CAP OVER THE
UNIVERSAL CONNECTOR
When a speaker/microphone is not
being used, install the cap over the
universal connector using the supplied
accessory screw (4 x 6 mm).
To keep the transceiver water resistant, you
Note:
must cover the universal connector with the cap or
the speaker/microphone connector.
The antenna
connector of the
transceiver is an
SMA male type
connector.
INSTALLING THE BELT HOOK
If necessary, attach the belt hook using
the two binding screws (3 x 6 mm)
which are supplied in the screw set.
Note:
If the belt hook is not installed, its mounting
location may get hot during continuous
transmission or when left sitting in a hot
environment.
3