Each Setting And Adjustment; Model Setting - Pioneer DVR-LX61D Service Manual

1

8. EACH SETTING AND ADJUSTMENT

8.1 MODEL SETTING

A
[Purposes]
When the MAIN Assy and/or TUJB Assy that are(is)
commonly used with another model are(is) replaced,
they(it) must recognize the model of this unit.
Items to be set: The model number, destination, and
region No. must be set.
B • Once the setting has been made, it can never be changed. Be sure to make the setting correctly.
[Notes]
• As this setting resets the Assy(s) in question to the factory-preset status, it is recommended that you obtain
the customer's consent beforehand.
[Procedures]
1 After the unit is turned on, the model name for the
original equipment manufacturer is displayed on the
TV monitor screen. Input "9696" on the remote control
unit for service to change it to the model name for
Pioneer.
C
2 The following screen is displayed on TV monitor.
Press four digits properly by using the remote control
unit for service,
according to the screen information.
D
3 Disconnect then reconnect the AC power cord of the
unit. Be careful not to impart vibration to the unit
immediately after the AC power cord is disconnected.
E
4 Reset the recorder to all its factory settings.
(Make sure that the recorder is on. Press and hold
(STOP) key and press
the front panel.)
The recorder turns off with all settings reset.
5 Press [ESC] then [DISP] keys by using the remote
control unit for servicing, and then confirm each
Model Name.
F
6 End
88
1
2
(STANDBY/ON) key on
DVR-LX61D
2
3
[Tool to be used]
Remote control unit for servicing
(GGF1381)
DVR-LX61D/WY VERSION : 0.14
SYSCON : RELEASE_179
Rev.1.7379
TUNERCON : 2.22
DRIVE : DVD-RW DVR-U13
1.10
PIC SERIAL : 007710217604
HDD INT : ----
HDD USE : ----
GNDB B : NOBKUP GNDB U : NOBKUP
DEVICE : E2R-FEx1.1 FLASH : 128M
REGION : 2 C : 0000000153
HDCP : 0000000153
DTB H : 450 DTB S : 108
DTB B : 13A6 OK
3
4
OK
OK
OK
OK
4