Advertisement
Preparation of Power Source
• Battery Installation
How to Connect the Interface Connector
I
:;)
",--0
CD
Press the tab and remove the
battery compartment
cover.
:;J
",--0
CD
Insert four dry cell batteries of size
"AA."
Make sure illustrated
the
batteries
are set as illustrated
in
the
i
battery co mpart ment.
CD
Replace the battery compartment
cover.
r
)
<j
Insert
the
interface
connector
as
shown in the figure.
Don't
insert and disconnect
when
power switch is on.
NOTE:
The interface
cable should be of a
shield type.
2
NOTE
1: When the batteries
become weak, the "LOW BATTERY" indication
will
light up. When this happenes, replace all four batteries with new ones.
2: Turn off the power switch when the unit is not being used. Ifthe unit is not
to be used for a long time, or if the AC adaptor is to be used for a long time,
remove the batteries to avoid the fluid leakage.
(Be
aware
that
even
commercially
available
batteries
which
are
guaranteed
may sometimes
leak.)
.AC
Power Adaptor
Connect the AC adaptor to the DC6V
jack, and then plug the adaptor cord
into a wall outlet.
NOTE
1: Be sure to use the AC adaptor of
DC6V.
2: The batteries will be automatically
disconnected
from
the
power
supply
circuit
when
the
AC
adaptor is connected.
3: If the unit is not used for a long time, disconnect the AC adaptor from both
the wall outlet and this unit's jack.
4: Don't connect and disconnect the AC adaptor when the disk is inserted in
the unit.
'\
,
I
'j
Power Switch On
Don't
turn
on and off the power
switch
when the disk is inserted in
the unit.
3
Advertisement
