Dell Edge 3000 Installation And Operation Manual page 50

C C loud LED
NOTE: To utilize the Cloud LED, download the necessary tools and drivers from www.dell.com/support.
One unique feature of the Edge Gateway 3000 Series is the Cloud LED. Cloud LED enables you to visually inspect the operational
status of the Edge Gateway by looking at the display light on the left panel of the Edge Gateway.
To enable this feature, you must expose and program a GPIO register on the Edge Gateway.
Follow these steps to control the Cloud LED on the Edge Gateway:
1. Download the Cloud LED utility from www.dell.com/support.
2. Extract the following files:
a. DCSTL64.dll
b. DCSTL64.sys
c. DCSTL64.inf
d. DCSTL64.cat
e. CloudLED.exe
NOTE: These files must be in the same directory.
3. Run the CloudLED.exe from Command Prompt or Power Shell with administrative rights. The accepted commands are as
follows:
• CloudLED.exe ON
• CloudLED.exe OFF
TPM Support
Windows 10 IoT Enterprise LTSB 2016 supports TPM 2.0. For more information about TPM resources, see
technet.microsoft.com/en-us/library/cc749022(v=ws.10).aspx.
System Shutdown and Restart
Click Start and then press Power then Restart or Shutdown the Edge Gateway.
LAN/WLAN Network configuration
Click Start and then type
Bluetooth configuration
Click Start and then type
Bluetooth from the menu on the left panel.
WWAN (5815) Network configuration
NOTE: Ensure that the micro-SIM card is already activated by your service provider before using it in the Edge Gateway.
For more information, see
Follow the Service Manual to install and configure the WWAN module and the corresponding micro-SIM card for the system. Follow
these steps after the WWAN module (5815) and the micro-SIM cards are installed:
1. Click Start and then type
2. Select Network & Internet from the Settings menu.
3. Locate the WWAN connection in the Wi-Fi section and select the entry to connect and disconnect from the WWAN adapter.
50
and open the Settings window. Select Network & Internet from the settings menu.
and open the Settings window. Select Devices from the settings menu and then select
activate your mobile broadband
and open the Settings window.
service.