Per-Session Shaping Using RADIUS
Prerequisites for Per-Session Shaping Using RADIUS
You must configure all traffic classes on the ISG before referencing the classes in policy-maps.
Before the ISG can construct and apply an ANCP-based dynamic service policy, you must configure and
apply QoS policy-maps on the ISG.
Restrictions for Per-Session Shaping Using RADIUS
Transient policies are not visible in the running-configuration file. Only the original policy configuration
is visible.
Configuring Per-Session Shaping Using RADIUS
To configure per-session shaping using RADIUS, perform the following configuration tasks:
•
•
Configuring a QoS Policy on the ISG
To configure a QoS policy on the ISG, use the following procedure.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
DETAILED STEPS
Command
Step 1
policy-map policy-map-name
Example:
Router(config)# policy-map child
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
6-6
Configuring a QoS Policy on the ISG, page 6-6
Configuring Per-Session Shaping on RADIUS, page 6-9
policy-map policy-map-name
class class-name
(Optional) priority
(Optional) police bps
exit
policy-map policy-map-name
class class-default
shape average mean-rate [[burst-size] [excess-burst-size]] [account {qinq | dot1q | user-defined
offset} aal5 subscriber-encap]
service-policy policy-map-name
Chapter 6
Purpose
Creates or modifies a policy-map. Enters policy-map
configuration mode.
policy-map-name is the name of the policy-map.
RADIUS-Based Shaping and Policing
OL-14660-03