Installing The Combisets - Miele ProLine CSDA 1010 Operating And Installation Instructions

 Push the second spacer bar against
the downdraft extractor and secure it
with the screws supplied.
 Remove the protective foil from
around the edge of the grease filter.
 Fit the grease filter in the downdraft
extractor.
 Fit the extraction grille. Ensure it is
correctly aligned at the front and
back.
 See "Connection for air extraction"
for further instructions on fitting the
ducting.
Flat ducting and accessories can be
obtained from retail outlets.

Installing the CombiSets

 Secure the four outer spring clamps
in the cut-out.
 Feed the mains connection cable
down through the cut-out.
 Starting at the front, position the
CombiSet in the worktop cut-out.
 Using both hands, press down evenly
on the edges of the CombiSet until it
clicks into position. When doing this,
make sure that the seal underneath
the appliance sits flush with the
worktop. This is important to ensure
an effective seal with the worktop.
Installation
35