Connecting The Controller Unit To The Network; Connecting The Controller Unit To The Management Hosts - Bosch DSA-N2E8X4-12AT Quick Installation Manual

18 en | Connection
5.2

Connecting the controller unit to the network

In case of a Bosch Video Recording Solution a host is an IP camera. To connect the controller
unit to the Ethernet one or two of two available iSCSI host ports must be connected to the
Ethernet. The iSCSI port connections will then be used by the IP cameras for video data
traffic.
To connect the controller unit to the network:
4
Switch topology
5.3

Connecting the controller unit to the management hosts

The management host directly manages storage arrays over an out-of-band network. This
section describes how to set up an out-of-band connection between the Ethernet port of a
controller unit and the management host.
To set up an out-of-band connection:
1.
2.
2017.12 | V1 | DOC
Connect the cable from the iSCSI host port of the controller unit to a port on the switch.
Note: Make sure that the iSCSI ports of the controller unit and the relevant IP camera
ports are in the same range on the switch.
1
Switch
2
1 Switch
3 Controller B - iSCSI host ports (RJ45
Base‑T)
Note: Optionally, use the optical host
interface ports.
Connect Ethernet cables between port 1 of controller A and port 1 of controller B to an
external Ethernet switch or hub.
Connect the management host to the Ethernet switch or hub.
3
2
Quick Installation Guide
DSA E-Series (E2800 12-bay)
Controller A - iSCSI host interface
ports (RJ45 Base‑T)
Note: Optionally, use the optical host
interface ports.
Bosch Sicherheitssysteme GmbH