Sharp CE-158 Instruction Manual page 34

All and more about Sharp PC-1500 at http://www.PC-1500.info
17. CSAVEr
Effective only when CO has been declared by the SETDEV statement.
• The contents of the reserve program is sent out on the RS·232C port in the internal code
(same as the CSAVE statement in the RESERVE mode) .
(General format)
CSAVErT "FILE NAME"
j
NOTE: Set the word length to 8 bits.
18. C I L OAD
Effective only when Cl has been declared by the SETDEV statement. (Only manua l operation
is permitted.)
• Program executed
in
the RUN or. PRO mode or reserve program executed
in
the
RESERVE
mode is received through the RS.232C pc>rt in the internal code mode.
[RUN, PRO
mode)
Cl)
(General format)
CLOADT "FILE NAME"
(RESERVE
mode)
(2) (General format)
CLOAD
T
"FILE NAME"
NOTE· l: Set the word length to 8 bits.
NOTE·2 :
Program will be N EW when an err'or or a break i:s met during loading operat ion.
19. CLOADa
Effoctive only when Cl has been declared by the SETDEV statement. (On ly manual operation
is permitted.)
• Program is received through the RS·232C port in the ASCII code.
(General format!
CLOAOa---+
• Length of one program line received through the RS·232C port must be 160 ASCII codes
at a maximum and that
it
should be wi thin 80 codes when converted into the internal code.
• When the program is to be lnaded from the RS·232C port. secure two seconds of all MAR Ks
{no signal) as an intergap between program lines}.
• When the line is headed by the CR code, it will terminate program loading operation.
NOTE: Wh en an error or a break is met during loading of the program. the program portion
already loaded in the memory stays stored in the memory.
32
Do not sell this PDF !!!