Table of Contents
Advertisement
Network cabling requirements
The network cables required for the switch module are as follows:
10BASE-T:
UTP Category 3, 4, 5 (100 meters (328 feet) maximum)
100-ohm STP (100 meters maximum)
100BASE-TX:
UTP Category 5 (100 meters maximum)
EIA/TIA-568 100-ohm STP (100 meters maximum)
1000BASE-T:
UTP Category 6
UTP Category 5e (100 meters maximum)
UTP Category 5 (100 meters maximum)
EIA/TIA-568B 100-ohm STP (100 meters maximum)
Operating environment
The environment must meet the following temperature and altitude requirements:
Temperature: 10° to 35°C (50° to 95°F)
Relative humidity: 8% to 80% non-condensing
Related publications
For more information, see the following product publications, which are available from:
http://ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5075938
Cisco Catalyst Switch Module 3110 and 3012 System Message Guide
Cisco Catalyst Switch Module 3110 and 3012 Software Configuration Guide
Cisco Catalyst Switch Module 3110G, 3110X, and 3012 Hardware Installation Guide
Cisco Catalyst Switch Module 3110G, 3110X, and 3012 Getting Started Guide
Cisco Catalyst Switch Module 3110 and 3012 Command Reference
Other documents:
IBM US Announcement Letter
http://ibm.com/common/ssi/cgi-bin/ssialias?infotype=dd&subtype=ca&&htmlfid=897/ENUS108-190
BladeCenter Interoperability Guide
http://lenovopress.com/bcig
BladeCenter Products and Technology, SG24-7523
http://lenovopress.com/sg247523
Related product families
Product families related to this document are the following:
1 Gb Embedded Connectivity
Blade Networking Modules
Cisco Catalyst Switch Module 3012 for BladeCenter (withdrawn product)
13
Advertisement
Table of Contents
