Table of Contents
Advertisement
Wire Ports (2)
(Polarity: Left +, Right –)
CAUTION
POSSIBLE
EQUIPMENT
DAMAGE
5. Set the radio's configuration. The transceiver is designed for
quick installation with a minimum of software configuration
required.
a. Connect a PC to the transceiver's DB-9
shown in
terminal communications program, such as HyperTerminal
(included with most Windows
few times to receive the ready ">" prompt on the screen.
PC Running Terminal Session
(19,2000 bps, 8N1)
6
Figure 5. DC Power Connector
The transceiver must be used with negative-ground sys-
tems only. The power supply used with the transceiver
should be equipped with overload protection (NEC
Class 2 rating), to protect against a short circuit between
its output terminals and the radio's power connector.
Figure 6
using a straight-through cable. Launch a
Figure 6. PC Configuration Setup
MDS SD4 Startup Guide
Invisible place holder
Lead
Binding
Screws (2)
Retaining
Screws (2)
COM1
systems). Press
TM
Invisible place holder
To COM1 Port
connector as
a
ENTER
Transceiver
05-4669A01, Rev. A
Advertisement
Table of Contents
