Provide Power To Scan Tool - Bosch MD-200 User Manual

User Manual | Mitchell Diagnostics | Scan Tool | 10 | en
ss01826
DEMO MAIN MENU - Tap Below To Begin Your Diagnostic Experience
Select Vehicle
Heavy Duty
Today is Thu, 04 Jan 2018.
Provide Power to Scan ToolI
ss01716
MD-200
1
Scan Tool Cable Connections
1. OBD II / DLC cable
2. 12 volt power cable (Use with vehicles that do
not supply power through DLC)
3. Scan tool
Power via vehicle DLC
1. Connect the OBD II / DLC cable to the scan tool.
2. Connect the OBD II / DLC cable to the DLC on
vehicle. Located within 18 inches (45.7 cm) of
steering wheel. Typically located on the driver's
side, under dash.
©Mitchell International, Inc.
OBDII Saved Diagnostic Data
Settings
3. Turn ignition ON.
Non-powered vehicle DLC setup
9:40
Some vehicles do not supply power through DLC. In
this case use the following procedure.
1. Connect OBD II / DLC cable to scan tool.
2. Connect OBD II / DLC cable to DLC on vehicle.
Browser
Typically located on the driver's side under the
dash.
3. Connect the 12 volt power cable to the scan tool
power port.
4. Connect the 12 volt power connector to the
vehicle power outlet
5. Turn ignition ON.
ss01717
2
1
2
Scan Tool Connected to Vehicle
1. OBDII/DLC Cable
2. DLC
3
3. Scan Tool
581624 | REV. B | 06.2017 | APDMD032018
3