Part Names; Printer Settings; Connecting The Cables - Epson UB-E04 User Manual

Part Names

LED (green) Ethernet
interface connector
Note:
Do not connect any equipment other than the Wireless LAN unit to the USB
Type-A connector.

Printer settings

If the TM printer has a memory switch or a dip switch for "#25 pin reset signal" or "#31
pin reset signal" setting, do not change the setting from Enable. Changing the setting
may result in the printer to stop operating.
Switch and function names may vary depending on the printer. For details, see the
Technical Reference Guide of the printer.
Do not remove the interface board from or install the interface board into TM
printer. Doing so may cause malfunction of the printer or the interface board.

Connecting the Cables

1. Make sure both the printer and the host computer are turned off.
2. Plug the Ethernet cable securely into the UB-E04's Ethernet connector until you
feel it click.
Do not connect a telephone line, a display module cable, or a drawer kick cable to
the Ethernet connector.
Note:
When the UB-E04 is installed, a customer display connector on the TM printer
cannot be used.
3. Connect the power supply cable to the printer.
LED (yellow)
CAUTION:
CAUTION:
USB Type-A
connector
2
Push button