The Operation Menu - Sony VPL-DX270 Operating Instructions Manual

The Operation Menu

The Operation menu is used for setting for the operations by using the menu or the remote
commander.
Items
Language
Status
Set Password
*1
Security Lock
Menu Settings
*2
Lock
Control Key
Lock
Notes
*1: You will not be able to use the projector if you forget your password. If you call qualified Sony
personnel because you have forgotten the password, you will be asked to verify the projector's
serial number and your identity. (This process may differ in other countries/regions.) Once your
identity has been confirmed, we will provide you with the password.
*2: Before operating this menu, it is necessary to input the password. Set the password in "Set
Password" (page 24) of the Operation menu.
24
The Operation Menu
Item descriptions
Selects the language used in the menu and messages.
On: All on-screen statuses are enabled.
Off: Turns off the on-screen displays, except for menus, warning messages
and messages from the message list.
1 Input the password with the MENU, V/v/B/b and ENTER keys. (The
default setting password is "ENTER, ENTER, ENTER, ENTER.")
2 Input a new password with the MENU, V/v/B/b and ENTER keys.
3 Enter the password again to confirm.
On/Off: This function enables restriction of the projector to authorized users
by password. The setting procedures for security locking are as follows:
1 Select "On" and press the ENTER key to display the setting menu.
2 Input the password that is already set.
When it is set to "Off," you can cancel the security lock. You are required to
input the password again.
If you fail to enter the correct password after three consecutive times, the
projector cannot be used. In this case, press the ?/1 key to go Standby mode
then turn on the power again.
Full: Locks all menu settings.
Startup: If this setting is set, the settings when the unit is turned on will be
locked. The settings can be changed when using the unit. If the unit is turned
off, the unit restores the initial settings (which are locked when the unit was
turned on).
Update: While set to "Startup," the changed settings will be saved and locked
by selecting "Update."
On/Off: When set to "On," locks all the control panel keys of the projector.
However, you can operate the following when set to "On":
• Press and hold the ?/1 key for approximately 10 seconds during Standby
mode.
c The projector turns on.
• Press and hold the MENU key for approximately 10 seconds during power
on.
c "Control Key Lock" is set to "Off" and enables operation of all keys on
the projector.