Technical Data - Bosch GHP 5-13 C Original Instructions Manual

OBJ_BUCH-1613-005.book Page 5 Wednesday, November 9, 2016 3:34 PM

Technical Data

Pressure washer
Article number
Rated power
Supply Temperature max.
Supply rate min. l/min
Rated pressure
Max. operating pressure
Flow rate l/min
Maximum inlet pressure
Kickback force at the gun to the
maximum pressure
Motor Insulation
Motor Protection
Detergent tank
Autostop function
Net impedance
Sound pressure level dB(A)
Uncertainty dB(A)
Sound power level dB(A)
Uncertainty dB(A)
Vibration total value m/s
Uncertainty m/s
Weight according to EPTA-
Procedure 01:2014
Protection class
Serial number See serial number (rating
plate) on pressure wash-
Mounting and Operation
Action
Delivery Scope
Insert dip stick for ventilation
Connect detergent bottle
Water connection
Clean the water filter
Connecting high pressure water supply hose/
nozzle
Adjust water pressure
Adjust water jet
Switching On and Off
Working Advice
Clean nozzle
Bosch Power Tools
Starting
GHP 5-13 C
For Your Safety
3 600 J10 0..
kW 2.3
°C 50
8.3
Your pressure washer requires an earth connection. The op-
erating voltage is 220-240 V AC/50 Hz or 220-230 V AC/
MPa 13
60 Hz according the product number indicated on the type
MPa 14
plate. Do not connect a 60 Hz designed product to a 50 Hz
8.3
supply and vice versa. Only use approved extension cables.
MPa 1
Contact your Bosch Service Centre for details
220 V – 240 V/50 Hz
N 22.11
3 600 J10 0F0
Class F
3 600 J10 0L0
IPX5
3 600 J10 0K0
3 600 J10 000
–
3 600 J10 070

If you want to use an extension cable when operating your
Ω
high pressure washer, only the following cable dimensions
84
should be used:
3
2
- 2.5 mm – max length 20 m
92
2
- 4.0 mm – max length 50 m
3
Note: If an extension cable is used it must be earthed and con-
2
2.74 nected through the plug to the earth cable of your supply net-
2 work in accordance with prescribed safety regulations.
1.5
If in doubt contact a qualified electrician or the nearest Bosch
Service Centre.
kg 16.5
/I
er.
Cable connections should be kept dry and off the ground.
It is recommended for increased electrical safety to use a Re-
sidual Current Device (RCD) with a tripping current of not
Figure
more than 30 mA. Always check your RCD every time you use
1
it.
2 If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
3
For products not sold in GB:
4
WARNING: For your safety, it is required that the plug at-
5
tached to the machine is connected with the extension cord.
The coupling of the extension cord must be protected against
6
splash water, be made of rubber or coated with rubber. The
7
extension cord must be used with a cable strain relief.
8 Drawing in water from open reservoirs
– Screw the suction hose with filter (special suction kit part
9
no. F 016 800 335) to the water connection.
10
– Switch on the appliance in low pressure mode.
11
– Let the appliance run for appx. 10 seconds, then switch
off. Repeat the procedure a couple of times until water ex-
iting is smooth and bubble free.
English | 5
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
220 V – 230 V/60 Hz
3 600 J10 0B0
3 600 J10 0P0
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
1 609 92A 3EL | (9.11.16)