GE WattStation Installation And User Manual page 27

The other authorization options in this tab are:
Allow RFID authorization when network down
•
This option gives WattStation owners the ability to make the RFID enabled WattStations
available during times of network outages.
Enable Local RFID authorization
•
This option gives WattStation owners the ability to make their WattStations utilize a local
database of cards which has been downloaded from the GE WattStation Connect. The
database can also be built up over time as cards are used and added to the local
database. When a card is used for the first time, the GE WattStation Connect will reply
back not only whether the card is authorized or not, but for how long it is authorized. That
information goes into the local database. Checking this option makes the authorization
immediate when the card is enabled per the local database.
RFID Test Mode
•
Checking both of these boxes (as shown above) on a WattStation configured for RFID
Access mode puts the unit into "RFID Test mode". RFID Test mode is a special case of RFID
Access mode. It means that an RFID card has to be swiped to use the unit, but it will
charge even if connection to the GE WattStation Connect has not yet been established.
RFID Test mode may be useful during the installation phase of the WattStation to allow for
test operation prior to the network connectivity being established.
© GE All Rights Reserved
27