Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNC600 Installation Manual

Part names and functions

G
A B C D E F
Microphone
Sensor range cap (Standard)
Infrared sensor

LED indicator

Lens unit
Speaker
M N
Used when registering the camera to the
hub.
Safety wire
Camera mounting stand
DC cable
LED indicator
You can use the LED indicator to confirm the
camera's status.
Indicator
Off
Green, lit
Green, blinking
slowly
Red
For assistance, please visit http://shop.panasonic.com/support
HNC600_(en_en)_0123_ver.201.pdf
H
I
*1
J

Setup overview

1
2
3
4
5
Status
No power, or LED
indicator is turned
*1
off
*1
Normal operation
Registration mode
Motion detected
15
Indicator Status
Red, blinking slowly Live images are
being viewed or
recorded
Red, blinking Camera is out of
range of the hub, or
device malfunction
Amber, blinking Camera is not
slowly registered to a hub
You can configure the camera so that its
LED indicator does not light during
normal operation. For more information,
refer to the User's Guide (page 26).
Initial setup
Make sure you can access the system
using your mobile device. For details,
refer to the System Setup Guide included
with your hub.
Registration
Required only if the camera was
purchased separately (i.e., not as part of
a bundle).
Confirm the installation area
Read the information in this document to
confirm that the desired installation area
is suitable to proper operation.
Installation
Install the camera in the desired location
and connect the camera to the power
outlet.
Adjust the infrared sensor range
Confirm the sensor range area and adjust
it if necessary using the included sensor
range adjustment caps.

Setup

15
2017/01/26 9:24:43