WASHING MACHINE P6091GW/YLP SERVICE Manual WASHING MACHINE CONTENTS Caution for safety during servicing 1. SPECIFICATIONS 2. OVERVIEW OF THE WASHING MACHINE 3. OVERVIEW OF THE CONTROL PANEL 4. TROUBLE DIAGNOSIS 5. DESIGNATION OF MAIN COMPONENTS 6. PCB SCHEMATIC DIAGRAM PCB CIRCUIT DIAGRAM 7.
Page 4
4. Trouble Diagnosis ♦ As the micom washing machine is configured of a complicated structure, there might be a need for a service call. The information below is prepared for exact trouble diagnosis and suitable repair guide. Caution for the Repair and Replacement Please follow instructions below for trouble diagnosis and parts replacement.
Page 5
4-1. Trouble Diagnosis Item Cause and treatment The power is not supplied - Is the PCB connector connected well? - Is the voltage normal? - Is the power supply plug connected well? - Is the noise filter connected well? - Is the secondary output of the power supply transformation normal? - Is the fuse disconnected? (option) •...
3. Overview of the control panel 1. Detergent dispenser Display panel 3. No Spin button Press to no spin program. 4. Rinse Hold button Press to rinse hold program. 5. Temperature button Press the button repeatedly to cycle through the available water temperature. (cold water, 30 °...
5. Designation of Main Components 5-1 Normal / Reverse Revolution of Motor and R. P. M. Control 1 2 3 4 5 6 7 8 9 10 Rotor Stator coil Rotor STATOR Stator coil WASHING MOTOR <Figure1> <Figure2> STATOR(5.1) ROTOR(8.9) TACHO(3.4) (6.7) "H"(mm) Code-No.
7. Assemble and Disassemble 1. ASS’ Y-COVER TOP 1) Remove two screws fixing the top-cover to back side. SCREW 2) Push the top-cover back about 15mm and pull it up. 3) It's possible to exchange and service the trans former, the pressure-senser, the noise-filter and the water valve.
Page 16
7. Assemble and Disassemble 3. BELT 1) Remove the top-cover. 2) Disassemble and assemble the belt. 3) Check that the belt is located at center of the motor-pulley. <When assembling the belt> PULLEY Hook the belt onto the motor pulley 1) and place it around the pulley 2).
8. Tools for Disassembly and Assembly TOOL 10mm Heater (1) 13mm Motor (1), Balance (5) Box driver 17mm 2 holes on each left and right of the shock absorber 19mm 1 Pulley hole Replaceable for the box driver. Double-ended 10, 13 Since the bolt runs idle when the box driver is used, use the box spanner 17,19mm...
Page 18
Caution for safety during servicing 1. Do not allow the customer to repair the product. The person may be injured or the product life may be shortened.. 2. Execute A/S after unplugging the power supply unit. Be careful of electric shocks. 3.
Page 19
1. Specifications WASH TYPE FRONT LOADING TYPE GROSS W 669 mm X D 656 mm X H 910 mm DIMENSIONS W 598 mm X D 550 mm X H 844 mm 50 kPa ~ 800 kPa WATER PRESSURE GROSS 80 kg WEIGHT 75 kg 5.0 kg (DRY LAUNDRY)