Beko D 5323 FW Programme Chart

Programme Chart and Quick Reference Card
How to cancel the washing programme
To cancel a programme while the machine is operating:
Press start/stop button for 3 seconds. The machine will drain the water inside the machine for 45
seconds. The programme is cancelled when washing light goes off. Then, you can choose and
start a new programme.
!
Important: Depending on the stage of the programme you have cancelled, there may be detergent
residue or rinse aid inside the machine and on the load. Make sure the items in the dishwasher are
not used before washing properly.
How to change the washing programme
To change the programme selection while the machine is operating:
Press start/stop button. The washing light will go off.
Select the new programme. Press start/stop button. The washing light will be on and new programme
will start.
!
Important: The new programme will NOT right from the beginning. It will start from the stage last
carried out by the previous programme selection.
1
Programme
symbols and
temperatures
Prewash
For rinsing
dishes that
will not be
washed
immediately
Detergent
compartment
-
A=25 cm³ /
15 cm³
B=5 cm³
programme
Prewash
sequence
End
Consumption
figures
Water (Liter)
4,2
Energy (kWh) -
14
Duration (min)
* Values declared on the product or in the operating instruction booklet / programme chart and quick reference card supplied
with the product are obtained in tests performed under controlled laboratory conditions and these tests are as defined in relevant
standards
**
Reference programme for the Testing Institute and energy labeling.
Testing program: Eco 50°C as compliant to EN 50242 international norms.
GB
2 3
Eco Intensive
50°C 65°C
Soiled Heavily
dishes that soiled dishes
have been that have
kept in the been kept in
machine the machine
OR Heavily
soiled dishes
requiring pre-
wash.
A A+B
Prewash
Prewash
50 °C wash 65 °C wash
Cold rinse Cold rinse
Hot rinse Hot rinse
Drying Drying
15 15,8
1,05 1,36
136 110
18 9829 01 00-04
Programme Chart and Quick Reference Card
Operating the dishwasher
Turn the tap on. Open the door of the machine.
Check that the upper and lower spray arms can rotate freely. Pour (Put in) the
detergent.
On / Off
Close the door of the machine.
Button
Push in the on/off button and check that the indicator light comes on.
Check the salt and rinse aid level indicators before you start the machine. If
necessary add salt and rinse aid.
Select the required programme by referring to the programme chart. Press the
Salt indicator
programme selection knob and it pops out. You will see the programme numbers
on the knob. Select the desired programme by turning the knob. Do not force
the knob.
On/Off
indicator light
Press start / stop button and check that the washing light comes on.
It will not affect the sequence if you leave the programme selection knob pushed
in or out.
Keep the knob pushed in to prevent children from tampering with the machine.
Do not open the dishwasher door whilst the appliance is in operation. However, in case
the door is opened while the machine is working, then a safety mechanism ensures the
machine immediately stops. Water may be very hot, so be careful.
! Care must be taken if opening the door, as steam and water will escape.
Press the on/off button after the programme is completed. The on/off indicator
light will go off.
Turn of the water tap, unload the baskets.
Start/Stop Button
Programme Sequence
The programme sequence throughout the washing process can be monitored
Progress
indicator lights from the progress indicator lights on the control panel.
Wash
Following the washing stage, in order to drain and remove water from inside
the machine completely, the machine will pause for approximately 35 minutes.
End
Do not worry this is not a fault. Then End progress indicator light will come
on.
Do not switch the machine off before End light comes on.
1 2 3
50°C 65°C
GB
On / Off