Using The Calibration Menu; Change Pin - GE Druck DPI 610 User Manual

Calibration

Using the Calibration Menu

The calibration routines are selected from the Settings menu as detailed on page 38.
Enter the calibration PIN number, initially set to 4321, press
the Calibration Menu.
PIN security
To prevent unauthorised access, it is recommended that the PIN number be changed as
soon as possible.

Change PIN

To change the PIN code, select CHANGE PIN from the calibration menu and proceed as
follows:
Note: To set and verify a new PIN, the new PIN code must be entered twice.
V v t
Enter New PIN
5 4 3 2
• If the second code entered differs from the first, the new PIN will not be set.
Calibrate Internal Ranges
Select the INT RANGES from the menu as shown above and follow the calibration
procedure on the display.
CALIBRATION
INT RANGES
EXT SENSORS
CHANGE PIN
SET NEW PIN
ATTENTION
CODE NON VALIDE
CALIBRATION
GAMMES INTER
CAPTEURS EXT
MODIFIE CODE
45
and the display shows
SELECT OPTION
Enter New PIN
SELECTIONNE
OPTION CAL
SET NEW PIN AGAIN
K415 Issue No. 1