Table of contents e n I n s t r u c t i o n m a n u a l Intended use ....5 Water softening system / special salt .
Page 4
Overview of programmes ..32 Cleaning and maintenance ..39 Programme selection... . .33 Overall status of the dishwasher . . . 39 Information for test institutes ..33 Machine Care .
Intended use en Intended use Safety instructions This appliance is intended T his appliance may be used by ■ I n t e n d e d u s e S a f e t y i n s t r u c t i o n s for use in the home and children over the age of 8 years domestic environments.
en Safety instructions Before you switch ON the Installation appliance Following installation, ensure ■ Please read the instructions for that the back of the use and installation carefully. dishwasher is not freely They contain important accessible (protection information on how to install, against contact due to hot use and maintain the appliance.
Safety instructions en Also follow the installation Please note that the ■ ■ instructions for the insulation material of the dishwasher to ensure that all dishwasher power cord may appliances are operated melt next to heat sources safely. (e.g. heating / hot water If there is no information or if installations) or hot ■...
en Safety instructions Childproof lock (door lock) * Open the door with activated T he child-proof lock (door lock) child-proof lock (door lock) as D o o r l o c k protects children from potential follows: Press the catch of the hazards which the dishwasher child-proof lock to the right poses.
Safety instructions en Childproof lock (button lock) Damage Y ou can prevent your The appliance may be B u t t o n l o c k dishwasher being switched off ■ repaired and opened up by a inadvertently (e.g. by children technician only.
Page 10
en Safety instructions Warning Warning Risk of injury! Risk of explosion! To prevent injuries, e.g. Do not add any solvents to the ■ caused by stumbling, open rinsing compartment. Danger of the dishwasher only briefly in explosion! order to load and unload the Warning dishwasher.
Environmental protection en Ensure that children do not Environmental ■ place fingers in the tablet protection collecting tray 1B. Small fingers could become caught B oth the packaging of new appliances in the slots. E n v i r o n m e n t a l p r o t e c t i o n and the old appliances themselves When opening and closing ■...
en Getting to know your appliance Appliance interior Getting to know your 1" Interior light * appliance 1* Cutlery drawer * 12 Top basket D iagrams of the control panel and the 1: Upper spray arm G e t t i n g t o k n o w y o u r a p p l i a n c e interior of the appliance can be found at 1B Tablet collecting tray the front of the manual.
Getting to know your appliance en Overview of menu Adjust the setting using the buttons + and - P. The dishwasher has been preset with Press and hold the ‹ button certain settings for your convenience. for 3 seconds. The settings can be found in the The chosen setting has now been individual chapters.
Page 14
en Getting to know your appliance Setting up Factory setting Description †– Tone volume * Volume of the signal. †–:‹ƒ †–:‹‹ - †–:‹„ ›– Button volume * Volume when using button. ›–:‹ƒ ›–:‹‹ - ›–:‹„ ’Ÿ Home Connect/Wi-Fi ’Ÿ:‹‹ / Off Switch wireless network connection on/off.
Home Connect en Wi-Fi | Home Connect Y ou can activate wireless network W i - F i connection with ’Ÿ:‹‚ or deactivate it T he availability of the Home Connect with ’Ÿ:‹‹. H o m e C o n n e c t function depends on the availability of Home Connect services in your country.
en Home Connect Network login Manual network login †‘: Switch on the ON/OFF switch (. T o connect the dishwasher to your Press and hold the ‹ button N e t w o r k l o g i n home network, you can choose for 3 seconds.
Home Connect en Connect to the app About data protection: When your Home Connect dishwasher T he setting ‘˜:˜ establishes the link is connected for the first time to a WLAN C o n n e c t t o a p p between the dishwasher, app and your network, which is connected to the user account.
en Home Connect Remote start button } Energy manager • I f the dishwasher is connected to the W ith the energy manager •, your R e m o t e s t a r t b u t t o n E n e r g y m a n a g e r home network, you can activate the dishwasher automatically starts during a...
Home Connect en Software update * Further information and system requirements for using the energy U sing the software update —˜ function manager can be found at S o f t w a r e u p d a t e you can update your dishwasher www.home-connect.com/energymana software (for example optimisation,...
Water hardness table directive 2014/53/EU. A detailed RED Declaration of Conformity can be found online at www.siemens-home.bsh-group.com on the product page of your appliance with the additional documents.
Water softening system/special salt en Adjusting the water softening Top up the special salt as follows: Undo the screw plug on the system dispenser 1b. Fill the dispenser with water You can set the amount of salt that (required only when switching on the should be added to a value between appliance for the first time).
en Rinse aid Setting amount of rinse aid Rinse aid You can set the amount of rinse aid that should be added to a value between The rinse aid ensures stain-free dishes R i n s e a i d and clear glasses.
Utensils en Switching off rinse aid refill Glass and utensil damage indicator Causes: Glass type and glass production If the rinse aid refill indicator )* ■ process. bothers you (e.g. if you are using a Chemical composition of the combination detergent with a rinse aid ■...
en Utensils Upper basket Lower basket Arrange cups and glasses in the upper Arrange pots and plates in the lower basket 12. basket 9*. * depending on the features of your * depending on the features of your dishwasher dishwasher Utensils must not be placed Heavily soiled utensils (pans) Note:...
Utensils en Cutlery basket * Depending on the features of your dishwasher, you can fold down the side P lace cutlery, always unsorted with the shelves to provide more room for taller C u t l e r y b a s k e t tips face down, in the cutlery basket *.
en Utensils Etagere * Folding spikes * T he etagere and the space underneath * Depending on the features of your E t a g e r e F o l d i n g s p i k e s can be used for small cups and glasses dishwasher, the spikes can be folded or for larger items of cutlery, such as...
Utensils en Small items holder * Baking sheet spray head * * Depending on the features of your * depending on the features of your S m a l l i t e m s h o l d e r B a k i n g s h e e t s p r a y h e a d dishwasher, the upper basket is fitted dishwasher...
en Utensils Unloading the dishwasher Appliance height 86.5 cm With cutlery basket Upper Lower To prevent water from dripping off the basket basket upper basket onto the utensils in the Setting 1 max. ø 24 cm 34 cm lower basket, it is recommended to empty the appliance from the bottom Setting 2 max.
Page 29
Utensils en Upper basket with side levers Upper basket with upper and lower pairs of rollers Pull out upper basket 12. Hold the sides of the basket along Pull out upper basket 12. the upper edge. Remove upper basket. This prevents it from suddenly Re-attach upper basket to the upper dropping.
en detergent Adding detergent Detergent If the detergent dispenser 9: is still Y ou can use tablets as well as powder closed, actuate locking bar 9B to d e t e r g e n t or liquid detergents for dishwashers, but open it.
detergent en If the utensils are only lightly You will obtain optimum rinsing and Tip: ■ soiled, slightly less than the indicated drying results by using solo amount of detergent is usually detergents and applying salt adequate. and rinse aid separately. Suitable detergents and care products If programmes are short, tablets may ■...
en Overview of programmes Overview of programmes T he max. possible number of programmes is illustrated in this overview. The O v e r v i e w o f p r o g r a m m e s corresponding programmes and their arrangement can be found on the fascia.
Overview of programmes en Type of dish Type of soiling Programme Possible Programme sequence additional options Time-optimised: u / t / part dried, common Cleaning 60° mixed utensils household food Intermediate rinse and cutlery remnants Rinsing Short 60°C Drying sensitive Time-optimised: ñ...
en Additional functions Ï intensiveZone * Additional functions P erfect for a mixed load. You can wash i n t e n s i v e Z o n e very soiled pots and pans in the lower * Depending on the features of your A d d i t i o n a l f u n c t i o n s basket together with normally soiled dishwasher, you can select different...
Operating the appliance en AquaSensor * Operating the * depending on the features of your appliance A q u a S e n s o r dishwasher The Aqua sensor is an optical P rogramme data measuring device (light barrier) which O p e r a t i n g t h e a p p l i a n c e measures the turbidity of the rinsing The programme data (consumption...
en Operating the appliance ¼ Sensor setting Zeolith drying Warning In its automatic programmes the Z e o l i t h d r y i n g appliance uses sensors to optimise Risk of burns from touching the blow their operation.
Operating the appliance en Auto Power Off Changing start programme (Automatic switch off after The Eco 50° programme for end of programme) environmentally friendly operation is always preselected when the appliance T o save energy, the dishwasher is A u t o P o w e r O f f is switched on.
en Operating the appliance Switching on the appliance Time preselection * * depending on the configuration of Turn tap fully on. T i m e p r e s e l e c t i o n your specific dishwasher Switch on ON/OFF switch (.
Cleaning and maintenance en Interrupting the programme Cleaning and maintenance Caution! Expansion (overpressure) may cause the appliance door to jump open and/or A regular inspection and maintenance water to escape! If the door was opened C l e a n i n g a n d m a i n t e n a n c e of your machine will help to prevent on an appliance which has a hot water faults.
en Cleaning and maintenance ‰ Notes Machine Care Only clean the appliance with ■ M achine Care used in combination with special detergents/appliance M a c h i n e C a r e commercially available machine cleaners which are suitable for use cleaning detergent is a suitable with dishwashers.
Cleaning and maintenance en Special salt and rinse aid Remove any residue and clean filters under running water. Top up the salt and/or rinse aid as soon Re-install filter system in reverse as either of the refill indicators on the sequence and ensure that the arrow control panel ): or )* lights up.
en Fault, what to do? Clean the waste water pump as Fault, what to do? follows: Disconnect the dishwasher from the E xperience has shown that you can power supply. F a u l t , w h a t t o d o ? rectify most faults which occur in daily Take out top basket 12 and bottom operation yourself.
Fault, what to do? en Fault table Fault Reason Solution "Check water supply" Supply hose kinked. Install supply hose without kinks. display lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be at least 10 l/min when water supply is open.
Page 44
en Fault, what to do? Fault Reason Solution Fault code “:ƒ… is lit. Wastewater hose kinked or Install hose without kinks, remove any blocked. residue. Siphon connection still sealed. Check connection to siphon and open if required. Cover on the wastewater pump Lock cover correctly.
Page 45
Fault, what to do? en Fault Reason Solution The Machine cleaning Machine cleaning cycle is Run the Machine cleaning cycle cycle display lights up. * recommended. programme without dishes using a special machine cleaning detergent. The display will go out automatically after 3 rinse cycles whether the Machine cleaning cycle programme is carried out or not.
Page 46
en Fault, what to do? Fault Reason Solution Appliance interior wet after No appliance fault. The physics of condensation drying rinse cycle. means that water droplets form on the container and are desirable here.The humidity in the air condenses on the inner walls of the dishwasher, runs down and is pumped out.
Page 47
Fault, what to do? en Fault Reason Solution Detergent residue Detergent dispenser cover 9: Dishes must not be placed above the blocked by dishes and therefore tablet collecting tray 1B.These may does not open fully. block the cover of the detergent dispenser and prevent it from opening fully.
Page 48
en Fault, what to do? Fault Reason Solution Stubborn white coatings on Detergent substances are Change brand of detergent. the dishes, container or deposited. These coatings cannot Clean appliance mechanically. door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than instructions for use or refill salt.
Page 49
Fault, what to do? en Fault Reason Solution Plastic parts discoloured. Rinsing temperature too low. Select programme with higher rinsing temperature. Dishes precleaned too intensely; Do not prerinse dishes.Remove only large sensors therefore opt for weak food remnants. programme sequence. Stubborn Increase sensitivity of the sensors.
Page 50
en Fault, what to do? Fault Reason Solution Appliance cannot be Malfunction. Disconnect appliance from the power switched on or operated. supply; pull out the mains plug or switch off the fuse. Wait at least 5 seconds, then connect the appliance to the power supply.
Page 51
Fault, what to do? en Fault Reason Solution Knocking or rattling noise. Spray arm strikes the dishes, Position dishes so that the spray arms do dishes not positioned correctly. not strike the dishes. If there is a small load, the water Load the appliance with more dishes or jets strike the washing tank distribute the dishes more evenly in the...
en Customer service Customer service Installation and connection I f you are unable to rectify the fault, C u s t o m e r s e r v i c e please contact your customer service. T he dishwasher must be connected We will always find an appropriate I n s t a l l a t i o n a n d c o n n e c t i o n correctly, otherwise it will not function...
Installation and connection en Delivery Installation Your dishwasher has been checked The required installation dimensions thoroughly in the factory to ensure that can be found in the installation it is in working order. This may cause instructions. Level the appliance with small water stains.
en Installation and connection Drinking water connection Hot water connection * * depending on the features of your Fasten the drinking water connection H o t w a t e r c o n n e c t i o n dishwasher to the tap according The dishwasher can be connected to...
Installation and connection en Electrical connection Transporting Empty the dishwasher and secure loose Connect the appliance to an ■ parts. alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz Drain the appliance according to the via a correctly installed socket with following steps: protective earth conductor.