Assembling The Forward Gear; Assembling The Drive Shaft; Installing The Drive Shaft - Yamaha E60HWD Service Manual

LOWR
2. Install the sleeve, original shim(s), and
drive shaft bearing outer race.
5
4
d
cC
Add or remove shim(s), if necessary, if
replacing the pinion or lower case.
NOTE:
9 Apply gear oil to the inside and outside of
the sleeve before installation.
9 Install the sleeve with the projection d fac-
ing forward.
Bearing outer race attachment 4:
90890-06626
Driver rod LS 5: 90890-06606
3. Install the original shim(s) and taper roller
bearing outer race.
6
cC
Add or remove shim(s), if necessary, if
replacing the forward gear or lower case.
Bearing outer race attachment 6:
90890-06621
Driver rod LL 7: 90890-06605
6-19
Lower unit
5
4
6F660290
7
G
6B460350

Assembling the forward gear

1. Install a new taper roller bearing into the
forward gear using a press.
Bearing inner race attachment 1:
90890-06662

Assembling the drive shaft

1. Install a new drive shaft bearing onto the
drive shaft using a press.
Bearing inner race attachment 1:
90890-06643

Installing the drive shaft

1. Install the forward gear, then the drive
shaft assembly, spacer, pinion, and pin-
ion nut.
2. Tighten the nut to the specified torque.
1
6B460310
1
2
6F60300
69D5G11