Advertisement
Precautions
In the Box
Device
Earphone /Two sets of ear tips
USB cable
Trubleshooting
Symptom
Cause & Solution
No power.
y
The battery is discharged. Recharge the battery.
ı
y
Check
selection switch.
Initialize the paring list by pressing 1 button and
y
button for more than 3 seconds at the same time, and then
reconnect to Bluetooth device.
Bluetooth pairing does
Be sure your Bluetooth device is on.
y
not work well.
Remove the obstacle in the path of the Bluetooth device
y
and the device.
Depending on the type of the Bluetooth device or
y
surrounding environment, your device may not be paired
with the device.
Be sure your Bluetooth device is on.
y
The volume of this device or your Bluetooth device is set to
y
minimum.
No sound or sound
When you use the other device at high volume, the sound
y
distortion.
quality may distorted. Lower the volume of the devices.
y
If you use this device for purposes other than listening to
music, the sound quality may be lowered or the unit may
not work properly.
Can not connect a call
y
Make sure your phone supports the Bluetooth® profile.
with the device.
y
Check the battery status by pressing 1 button twice.
The device does not
Please contact customer service.
y
operate normally.
Specifications
General
Power Supply
5 V 0 2.0 A (USB cable) / Built-in rechargeable battery.
Earphone jack
Ø 3.5 mm
Bluetooth® V 3.0
y
Communication
Range of Frequency: 2.402 GHz — 2.480 GHz
y
Stand by: Up to 10 days.
y
Operating time
Talk and Music play: Up to 8 hrs.
y
Charging time
Less than 2 hrs.
Dimensions (W x H x D)
Approx. 35.9 mm x 50.2 mm x 19.2 mm
Net Weight (Approx.)
18.4 g
Operating temperature
5 °C — 45 °C
Operating humidity
Less than 65 %
Design and specifications are subject to change without notice.
y
Safety Information
Declaration of Confirmation
FCC Notice to Users:
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Important Note:
To comply with the FCC RF exposure compliance requirements, no change to the antenna or the
device is permitted. Any change to the antenna or the device could result in the device exceeding
the RF exposure requirements and void user's authority to operate the device.
Federal Communication Commission Interference Statement.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
y
Reorient or relocate the receiving antenna.
y
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
y
connected.
Consult the dealer or an experienced radio/TV technician for help.
y
CE Notice to Users:
Hereby, LG Electronics Inc. declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
FCC ID: SSNBTS1
Advertisement
