Related Manuals for Samsung SWF-P8IW/XEH
Summary of Contents for Samsung SWF-P8IW/XEH
-
Page 1: Table Of Contents
WASHING MACHINE SWF-P8IW/XEH SWF-P10IW/XEH SERVICE Manual WASHING MACHINE CONTENTS 1. SPECIFICATIONS 2. OVERVIEW OF THE WASHING MACHINE 3. OVERVIEW OF THE CONTROL PANEL 4. PROCESS TABLE 5. GENERAL REEOR FUNCTION 6. TROUBLE DIAGNOSIS 7. TEST MODE 8. DESIGNATION OF MAIN COMPONENTS 9. -
Page 2: Caution For The Safety During Servicing
19. When the wash-heater is replaced, check it is inserted in the bracket-heater and screw the nut. If the wash-heater is not inserted in the bracket-heater properly, this may cause the noise and leakage since it is contacted to the drum. SAMSUNG ELECTRONICS CO., LTD... -
Page 3: Specifications
MODEL SWF-P8 SWF-P10 SWF-P12 220 V 430 W 500 W 550 W 240 V 430 W 500 W 550 W PUMPING 34 W WATER CONSUMPTION 54 (STANDARD COURSE) SPIN REVOLUTION MODEL SWF-P8 SWF-P10 SWF-P12 1000 1200 SAMSUNG ELECTRONICS CO., LTD... -
Page 4: Overview Of The Washing Machine
2. Overview of the Washing Machine WATER SUPPLY VALVE CONTROL-PANEL DRAWER ASSY DOOR SENSOR PRESSURE ADJUSTABLE LEG ASSY PUMP POWER CORD BUFFER SPRING WEIGHT-BALANCE DRAIN HOSE PULLEY BELT SHOCK ABSORBER ASSY MOTOR SAMSUNG ELECTRONICS CO., LTD... -
Page 5: Overview Of The Control Panel
Press once to turn the washing machine on, press again to turn the washing machine off. If the washing machine power is left on for longer than 10minutes without any buttons being touched, the power automatically turns off. SAMSUNG ELECTRONICS CO., LTD... - Page 6 SAMSUNG ELECTRONICS CO., LTD...
-
Page 7: General Error Function
- At the time of initial water supply, if the water temperature is not appropriate, water starts to be drained and it is forced to be drained for 2 min when the abnormal frequency of 25.24KHz is detected. - Display shows ‘E8’. - This error can be cleared by POWER S/W OFF. SAMSUNG ELECTRONICS CO., LTD... -
Page 8: Trouble Diagnosis
5) As the parts on P.C.B are coated by the urethane, they can not be tested by the test bar of the meter. Check the trouble by the test mode method according to the procedure. SAMSUNG ELECTRONICS CO., LTD... - Page 9 The heating is not executed. - Is the wash heater terminal unplugged? Ω - Is the wash heater normal?(Resistance value : 20.5~21.5 - If above points are not found, the PCB assembly is out of order. Replace it. SAMSUNG ELECTRONICS CO., LTD...
-
Page 10: Test Mode
B. Display shows ‘0000’ and the machine starts to measure the dropping time from 600 RPM to 100 RPM for 1minute. C. After setecting the amount of load, it display the data in a hex value. SAMSUNG ELECTRONICS CO., LTD... -
Page 11: Designation Of Main Components
1) Capacity : AC 230V/2500W 2) Location : Bottom of TUB 3) Function : Raise the water temperature Thermistor supplied at the wash process. 4) Resistance value : 20.5Ω ~ 21.5Ω 5) Thermo Fuse : 128°C SAMSUNG ELECTRONICS CO., LTD... -
Page 12: Assemble And Disassemble
5) Part the diaphragm and the wire diaphragm away from the frame-front. 6) Remove the eight screws fixing the frame-front. 7) It’s possible to exchange and service the heater, the pump, the shock-absorber and the door lock s/w. LEVER SAMSUNG ELECTRONICS CO., LTD... - Page 13 4) Remove the motor. Motor Assemble Hole 5. How to Assemble the RELAY Housing. Relay <CAUTION> Insert the Relay Housing to the Relays on the opposite direation each other. RELAY Housing Heat Sink SAMSUNG ELECTRONICS CO., LTD...
-
Page 14: Tools For Disassembly And Assembly
17mm. Vice pliers Tool to protect the idle and abrasion of the bolt for the box driver. Other(Driver, Nipper, Long nose) General tools for the after service. JIG for the Tub 1 (Disassemble and Assemble) SAMSUNG ELECTRONICS CO., LTD... -
Page 15: Expolded View And Parts List
SBHG-R T3 BRACKET-HEATER DC61-40344A STS430 T1 SPACER-HEATER DC61-60496A VANE-CHECK DC62-20311A EPDM BLK WASHER-PLAIN DC60-60188A ID4.5 OD15.5 T1 ASSY-DRUM DC91-12281A SWF-P8/P10/P12 PACKING-TUB DC62-40183A EPDM BLK TUB-BACK DC61-30347A PP(GR30%) IVORY CLIP-TUB DC61-60499A HSWR CLIP TUB(P) DC61-60520A SK5 ZPC3 SAMSUNG ELECTRONICS CO., LTD... - Page 16 12. Expolded View and Parts List SAMSUNG ELECTRONICS CO., LTD...
- Page 17 DC60-60060A WASHER-SPRING DC60-60049A ID10.5 OD18 T2.5 SIR NUT-HEX DC60-50014A HEXAGON M(12) ZPC2(YEL) SM10C BELT-TRANSMISSION DC66-10139A MOTOR-DRUM DC31-00002C 13000rpm 100Nm 220~240VDC 1.8A CUSHION-MOTOR DC61-00041A NBR SWF-P12 ID13.4/OD28 BOLT-W.MOTOR DC60-40138A M8 L70 ZPC2(YEL) SM10C PIN-SPLIT DC60-80175A ZPC2(YEL) SM10C SAMSUNG ELECTRONICS CO., LTD...
- Page 18 12. Expolded View and Parts List SAMSUNG ELECTRONICS CO., LTD...
- Page 19 PW1 PI23 FRAME DC61-30342A SBHG1-A NTR ASSY-LEG DC91-12292A DAMPER-SHOCK DC66-60149A BOLT-HEX DC60-40026A M10 SCP COVER-FRONT(L) DC61-10672A PP(BJ-730) WHT CAP-DRAIN DC61-10673A PP WHT HOSE-DRAIN DC62-10302A EPDM ID5.5 BLK L220 OD9.5 ASSY-PUMP DRAIN DC90-11110A 220/240V50Hz HOSE-WATER(C) DC62-10289A PVC+WHT+1500 SAMSUNG ELECTRONICS CO., LTD...
- Page 20 12. Expolded View and Parts List 1-1 Safety precautions Description Code No. Q’ty Secification DECORATION-LID DC64-20013A ABS SWF-P8, P10 COVER-DOOR DC61-10682A ABS WHT DOOR-GLASS DC61-00013A GLASS NTR SWF-P12 HOLDER-GLASS DC61-40346A ABS WHT ASSY-HINGE DC97-00100A LEVER-DOOR DC66-30161A ZnDC L40 NUT-FLANGE DD60-50018A SAMSUNG ELECTRONICS CO., LTD...
- Page 21 DC97-00003B INLAY-ENCODER DC64-30087C PC TRP SWF-P12, YLP/YLR/YLU BUTTON-ENCODER DC64-10408A ABS WHT KNOB-ENCODER DC64-10407A ABS WHT ASSY-PCB URETHAN DC90-11195A SWF-P10 EU(COLD) ASSY-PCB URETHAN DC90-11196A SWF-P8 EU(COLD) ASSY-PCB URETHAN DC90-11185A SWF-P12 FRAME-PLATE(U) DC61-30344A EGI, WHT ASSY-HOUSING DRAW DC91-12084A SAMSUNG ELECTRONICS CO., LTD...
- Page 22 ELECTRONICS © Samsung Electronics Co., Ltd. Mar 1999 Printed in Korea Code No. : DC68 - 00133A...
-
Page 23: Pcb Schematic Diagram
9. PCB Schematic Diagram SAMSUNG ELECTRONICS CO., LTD... - Page 24 9. PCB Circuit Diagram SAMSUNG ELECTRONICS CO., LTD...
- Page 25 9. PCB Pattern Diagram, Wriring Diagram SAMSUNG ELECTRONICS CO., LTD...