HP RP7 Retail System Model 7100
NOTE: This step may not be necessary if
the security screw is already loosened.
NOTE: Inserting the screws is a
required step.
Adjusting the LCD Screen
There are three small holes on the rear of the LCD used to adjust the
screen. Insert a thin metal rod, such as a paper clip, into the holes to make
the adjustments.
•
Top hole - turns power on and off
•
Middle hole - decreases brightness
•
Bottom hole - increases brightness
Online Technical Support
For the online access to technical support information, self-solve tools,
online assistance, community forums or IT experts, broad multivendor
knowledge base, monitoring and diagnostic tools, go to
http://www.hp.com/support.
CAUTION: You must rotate antenna
brackets up to remove front panel.
NOTE: Tightening the security screw
is optional.