Using The Controls - LG LP1415GXR Service Manual

6. OPERATION

USING THE CONTROLS

Control panel buttons shown. Operation
using the remote control is the same, unless
specifically noted.NOTE:The remote sensor is
located under the air discharge and on the top
of the front panel.
POWER
Press the POWER button to turn the air
conditioner ON or OFF. When you turn the air
c onditioner on, an ascending
tone will play and the LED
display will show the set
temperature and any active
mode.The air discharge on the top of the air
conditioner wil automatically open.
When turning the air conditioner off, you will
hear a descending tone and the air discharge
on the top of the air conditioner will close.
Any control settings such as Mode, Set
Temperature, Auto Swing, etc. will be retained
in memory when the power is off.
NOTE: When turned on after being unplugged,
the air conditioner will automatically reset to
COOL mo d e, with a temperature setting of 22°C .
Any settings will need to be re-entered.
Copyright ©2014 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Always point the remote at the sensor. The
remote may not work if the sensor is in bright
light or if there is not a clear path between the
remote and the sensor.
MODE
Press the MODE button to select the operating
mode(COOL,FAN,DRY , ENERGY SAVER)
for the air conditioner.
And you can see the active
mode through the LED Display.
The default setting is COOL.
Press the MODE button to
change to FAN, press again to change to DRY,
again to change to ENERGY SAVER
and again to return to COOL.
COOL
ENERGY
SAVER
Mode Features
Compressor runs and cools the room. Use the
COOL
/ and FAN buttons to set the desired
temperature and circulation fan speed.
FAN Fan circulates air but compressor does not run.
Use the FAN button to set the desired fan speed.
DRY Dry mode is used to remove humidity from the room
without additional cooling. Once the set temperature
is reached, the compressor and circulation fan turns
off and only the exhaust fan will run. Fan speed is
pre-set and cannot be adjusted.
ENERGY Under normal operation, the exhaust fan cycles on
and off with the compressor, and the circulation fan
SAVER
runs at the set speed.
The mode helps reduce power consumption by
automatically turning off the circulation fan as well
as the exhaust fan when the compressor is off. The
air conditioner will automatically cycle both fans on
and off with the compressor as needed for cooling.
- 17 -
→
FAN
DRY
LGE Internal Use Only