Thank you for purchasing this Panasonic product. Please read these instructions carefully before attempting to install,operate or service the Panasonic product. Failure to comply with instructions could result in personal injury or property damage. Please explain to users how to operate and maintain the product after installation, and this booklet should be presented to users.
GENERAL SAFETY INFORMATION For Your Safety To reduce the risk of injury, loss of life, electric shock, fire,malfunction, and damage to equipment or pro always observe the following safety precautions. Explanation of symbol word panels The following symbol word panels are used to classify and describe the level of hazard, injury, and property damage caused when the denotation is disregarded and improper use is performed.
IMPORTANT INSTRUCTIONS CONTINUED WARNING Do not use out doors. Use only on 20 ampere branch circuit. To prevent a possible fire, do not block air intakes or exhuast in any manner. A statement to the effect that when the product is to no longer be used, it must not be left in place but removed, to prevent it from possibly falling.
Fig.B DESCRIPTION The Panasonic Fan Heater is specially developed for bathroom heating. It uses a sirocco fan driven by a capacitor motor. The motor is designed to have an extended service life with reduced energy consumption. It also incorporates a thermal cut-off for safety. The louver covering the main body is screw-fixed type.
WIRING DIAGRAM INSTALLATIONⅠ(BETWEEN JOIST MOUNTING) Top view of the recommended installation. Unit:inches(mm) Wall Unit:inches(mm) Air duct Product Bathroom Bathtub 3" Fig.1 (450) Suspension brackets The bathroom size may affect the Hanger room heating result of this product. holder 3" 3" 1.Make a hole of 10 inch(270 270mm in the ceiling between j ist.(Fig.1)
INSTALLATION Ⅰ(BETWEEN JOIST MOUNTING-Ⅰ) CONTINUED ③ Refer to wiring diagram (Page.6) or Fig.9, Brown to Red to Blue to wall switch wall switch wall switch follow all the local electrical safety codes. As well as the National Electrical code Wire nut (NEC),Using UL approved wire nuts, connect house power wires and control Green to earth...
Page 9
INSTALLATION Ⅰ(BETWEEN JOIST MOUNTING-Ⅰ) CONTINUED 8.Use one of the ST4.2X30 self-tapping srews provided in the accesso y package to fix the product frame and the hanger unit.(Fig.12) Fig.12 9.Install plates locked. Using 2 of the ST4.2X30 self-tapping screws provided in the accessory package to lock the install plates (Fig.13),make sure the screws are go through the hole of install plates,and the drywall is clampped tightly.(Fig.14)
Page 10
INSTALLATION Ⅰ(BETWEEN JOIST MOUNTING-Ⅰ) CONTINUED ④ Fix the louver assembly with the 3 of the M4X8 mechanical screws in the accessory. (Fig.18) ⑤ Install the filter mesh again and attach the Fig.18 Screw caps(2 pcs) unclenched screw caps again.(Fig.19) 10.Paste the switch label provided in the accessory package on the switch panel.
INSTALLATION Ⅱ(JOIST MOUNTING) 5.Follow step 5 of installation Ⅰ(page 8) to complete the connection of power wires and control lead wires. 6.Main body fixed. Push the main body upward into the ceilling, Fig.25 use 4 of the ST4.2X30 self-tapping screws provided in the accessory package to fix it.
Warning Concerning Removal of Covers. The unit should be serviced by qualified technicians only. Your product is designed and manufactured to ensure a minimum of maintenance. Should your unit require service or parts,call panasonic Call Center at 1-866-292-7292 (USA) or 1-800-669-5165 (Canada). X0113-0 07VFH34200...