Motorola MTP810 Ex Quick Start Manual

MTP810 Ex
Quick Start Guide
LED Status Indicator
1
1 Antenna
2 Emergency Button
2
3 Programmable Rotary Knob
3
19
4 Earpiece
18
4
5 Programmable Side Key
5
6 Push-To-Talk Button (PTT)
17
6 7 Soft Key
16
5 8 Send Key
7 7 9 Speaker
8 15
10 Bottom Microphone
14
11 Side Connector
9
Battery Capacity Information
12 Battery Latch
13
10
13 Speaker Control Key
14 Four Way Navigation Key
15 On-Off/End/Home Key
11
16 Menu Key
17 Color Display
10
13 18 Top Microphone
19 LED Indicator
12
Indicator Status
Solid green In use
Flashing green In service
Solid red Out of service
Connecting to a network
Flashing red
Entering DMO
Solid orange Transmit Inhibit in service
Channel busy in DMO
Flashing orange Incoming private or phone call
No indication Switched off
Information Description
Green icon Full (50% – 100% capacity)
Yellow icon Middle (20% – 50% capacity)
Red icon Low (10% – 20% capacity)
Empty icon Very low (5% – 10% capacity)
Low battery message Less than 5% capacity
Installing the Battery Unlocking/Locking Keys
To unlock/lock the keypad, press the Menu button and then Left Navigation
Key.
How to Hold Your Terminal
The terminal has two microphones: a top microphone for Simplex
Battery installing must occur only in non-hazardous areas.
dispatcher/private calls and a bottom microphone for Duplex telephone-like calls.
Remove the battery from its protective case.
When using low audio, hold your terminal as you would a telephone. Speak into
Insert the battery top into the compartment - ensure that the latches on the
the bottom microphone. Listen via the earpiece. Keep antenna at least 2.5
radio fit into the slots on the battery as illustrated on the left.
centimetres from your head and body.
Carefully slide the battery towards the top until it clicks into place as
illustrated on the right.
Attaching the Antenna
When using high audio, hold terminal in a vertical position with its top microphone
5 to 10 centimetres away from your mouth. Speak into the top microphone. Listen
via the terminal's internal speaker. Keep antenna at least 2.5 centimetres from
your head and body.
Antenna attaching must occur only in non-hazardous areas.
Turn the terminal off before attaching the antenna.
Align the bottom of the antenna and the screw-in base on the top of the
terminal.
Turn clockwise until snug. Do not force.
Looking After Your Terminal
Unlocking the Terminal
Never leave your terminal or battery in extreme temperatures (over 60 °C) - for
example, behind windscreen in very hot, direct sunlight.
Your terminal may be locked at power up. To unlock the terminal after
Do not immerse your terminal in water.
powering on, enter the code at the prompt using Software Numeric Keypad.
To clean your terminal, use a moistened or antistatic cloth.
The unlock code is originally set to 0000. Your Service Provider may change
Do not use a dry or electrostatically charged cloth.
this number before you receive your terminal.