Motorola SDC1000 Operating Manual page 14

SDC1000
Command Change setting values
41 Unconditional Door Open
42 Unconditional Door Close
43 Enable QUICK ACCESS MODE(Operate only PIN MODE)
44 Disable QUICK ACCESS MODE(Operate only PIN MODE)
51 Disable Melody sound
52 Enable Melody sound
60 Change keypad lock time when Try Out error detected
61 Detect AUX#1 Input from 'L' to 'H'
62 Detect AUX#1 Input from 'H' to 'L'
63 Detect AUX#2 Input from 'L' to 'H'
64 Detect AUX#2 Input from 'H' to 'L'
65 Detect AUX#3 Input from 'L' to 'H'
66 Detect AUX#3 Input from 'H' to 'L'
67 Detect Exit Button Input from 'L' to 'H'
68 Detect Exit Button Input from 'H' to 'L'
69 Detect Door Contact sensor Input from 'L' to 'H'
70 Detect Door Contact sensor Input from 'H' to 'L'
71 Activate TTL output to 'H'
72 Activate TTL output to 'L'
77 Enable Chime Bell Output
78 Disable Chime Bell Output
80 Set delay time to activate SECURE MODE
81 Set watch-dog time for Door Contact sensor
82 Set number of times of Try-Out
83 Set input limit time from the keypad
84 Set Temper Alarm port
88 Enable Temper Alarm
89 Disable temper Alarm
99 Initialize and erase all setup data
SINGLE DOOR ACCESS CONTROLLER
- 14 -
MOTOROLA